Your Flexispot Kontakt

Flexispot Standing Desk Evaluation …Flexispot Kontakt…

Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a couple of functions that I wasn’t necessarily a big fan of:

The package that the desk came in was heavy, so bringing it inside was a group effort, however this is simply an effect of how durable the Flexispot is.
The convenient cable tray was a little bit complicated to set up. In the end, you ultimately slip it under screws, which wasn’t very clear from the directions.
You will need to buy an anti-fatigue mat to stay comfy, however this is a good concept for any standing desks, so I can’t fault Flexispot for that.

When it arrived and I saw how heavy it was, I was both fired up (since this indicated it was going to be durable) and also a little reluctant (due to the fact that all of us know how much of a challenge assembling furnishings can be).

Fortunately, with the help of an instructional YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some guidance from me, from start to finish. The only problem I have with assembly was the cable television tray, which I discovered wasn’t explained well in the directions.

When assembled, I like the streamlined look of this desk. I’m positive any of the many varied finishes that it comes in would look excellent in any workplace, and the adjustable width makes it easy to fit it in even the tiniest of office.

The quiet operation and height memory settings make it simple, efficient, and peaceful to switch in between sitting and standing as often times as you want throughout the day.

This desk is strong. It can hold up to 335 pounds even while in operation, so if you have a large desktop computer (or wish to take a nap on it for some reason) it has you covered. It will also uniformly distribute weight no matter how out of balance the weight you put on it is, it will not wiggle or wobble.

 

in that video is quite kitted out as the desk we’re looking at today is pretty fundamental I tried to get as near to that as I could on uplifts site with comparable setups the flexi area desk we’re taking a look at today will run you about four hundred and ten dollars versus six hundred and fifty for a comparable desk from uplift I try to get as close as possible with the uplift design is really five inches longer however you can do a lot with five inches boom yes now for transparency flexi spot did send this desk out for evaluation however as you ought to understand by now does not affect my evaluation in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping till the end of April at the earliest the desktop is an inch thick but it’s this standard laminate as you can perhaps get doing not have even any cable television grommets for pass through the outside container

for the desktop was not damaged in any way which is absolutely bizarre due to the fact that I might shoot a 30-second b-roll montage of simply the damage and flaws on this desktop scuffed scraped pitted just incredibly rough guy if I had actually purchased this I ‘d have been on the phone with customer support immediately they did also managed to miss drilling the pilot holes where you can attach the control box to the desktop a lot of having to do that myself without accidentally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was actually quite simple the entire thing came together in about 45 minutes and despite the fact that there’s cables running to it from each part to support motorized function unusually definitely where any sort of cable television management products whatsoever the frame on this unit is a single motor dual stage design versus the double motor three-stage style that comes requirement with the uplift desk this can be updated also to both the double phase dual motor and a three-stage dual motor which presses the expense of the desk up

an additional 70 dollars the frame is created for a max load of 154 pounds and it moves at a rate at an inch per second the height can vary from simply under 28 inches to simply over forty seven point 6 inches so a max I ‘d it is more than tall adequate even for me and I remain at 6 foot for this design does come standard with the control panel that permits up-and-down motion plus 3 memory spots with an LED readout to inform you the desk height the single motor design utilizes this drive shaft assembly which has to be adjusted as the width of the desk is adjusted the motor operation itself while it might be sluggish is really quiet as in barely audible this outside a rate would be the one advantage I would offer this unit over the uplift desk and I want to take care here due to the fact that this isn’t a hit piece this desk is 240 dollars more affordable than the comparable uplift model over 35% more affordable even if you update this flexi area test to the dual motor three-stage style it still comes in a hundred and seventy dollars more affordable than the uplift however cheaper does not indicate inexpensive this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is strong even if max height I’ll absolutely give it that however the lateral stability of this desk the horizontal movement at this rate point it’s inappropriate it’s add fuel to the fire here they consist of a little security baffle this little steel piece that installs to the frame and covers a part of this rotating driveshaft when

this desk sees any lateral motion at all the drive shaft hits this baffle and the noise is absolutely frustrating to leading things off I decided to add rolling casters to this desk this was a $30 upgrade and two of those 4 casters arrived damaged also my prepare for this desk at this point is to lose the desk top and came with all together and replace it with a white laminate lemon table from Ikea and use it as an adjustable photo table which you can’t do this frame will accommodate desktops up to 63 inches broad and 31 and a half inches deep so this will roll around the studio make it much easier to film items without needing to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift first that is a financial investment in quality workplace furniture that will last you this at finest seems like a cheaper replica of that it just does not feel quality and the distinction in between this desk and my main desk is night and day do do not hesitate to check out their website too which also feels strangely similar to one of their competitors there’s a wealth of devices you can get for the flexi area desk approximately and consisting of a foot massager and even a stationary stationary bicycle and I could invest another 10 minutes of our precious time covering different options and devices I might however I think I’m happier that they just sent out a standard desk due to the fact that as a standard desk I’m not a fan of the quality assurance at this rate point and I do not believe slapping on a lot of bonus is the relocation when the core item isn’t what it need to be they do provide a 30-day trial if you’re just morbidly curious and they guarantee their desks for three years really desk is 5 years and uplift desk is 7 years if you are Flexispot Kontakt

in the market for a sit-stand desk they’re incredible mine’s been a life changer for me both in terms of video gaming and productivity however I would invest the additional money it’s gon na require to get into a higher end producer like uplift desk or extremely desk and I have not personally used very desk items so I can’t speak on it however their credibility is great huge thanks to flexi spot for sending this out for review unfortunately I can not recommend this system and for the record I’m a hundred percent sure they would have happily changed the parts that I had an issue with seeing as how both the desktop and the casters showed up damaged but from a client standpoint you ‘d probably be truly thrilled to get this in